View Full Version : Trouble with channel switching on my amp
09-07-2006, 09:46 AM
I have a Tech 21 Trademark 300 head and I have tried to get the amp control function to work with my GT Pro. I thought that the only thing I needed to do was to select the channel I wanted to use, active the amp ctl and store it at the desired patch. What happens is that when I change patch is that the GT Pros changes the channel but not to the desired but to the next in line, that is: From Clean to Rythm, Rythm to Solo and Solo to Clean. I would like to assign a patch with the clean channel, another with the rythm channel and so on. Is there a problem when I use a three channel amp or am I doing anything wrong?
09-07-2006, 12:06 PM
I'm fairly sure that the pro's amp control function is the same as that on the GT8, and as such it is intended to switch a 2 channel amp... clean to lead and back again.
there is (as far as I am aware) no way of discerning which amp channel you use for each patch with the amp control function.
09-08-2006, 09:13 AM
Ok, then I have to buy a separate midiconverter. Do I have to buy one that is made for my amp, like the ARMD MIDI Converter, or doesn´t it matter?
09-11-2006, 07:11 AM
It seems that the tech21 channelswitching does not use a standard method (because it loops through the channels...). This can couse problems if you don't have a tech21 deddicated switcher. Do you have any info (manual?) how the channels are switched (connections)?
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.